Durability
Gloss Resistant
coated should be clean, dry, free from moisture ,dampness and other contamination
For hard wood, sand the surface using Sandpaper #80, followed by Sandpapers #120, #150, #180 and #220
For Veneer ply surfaces,start with Sandpaper #220
This step wise approach makes the surface smooth
Always sand in the direction of the wood grain
Mix the base thoroughly prior to mixing with the hardener
Avoid applying in direct sunlight or when the humidity is very high
Apply 2 to 3 coats of Melamine Sealer clear with an interval of 8 hrs between subsequent coats. Sanding should be done prior to the application of each coat. The number of coats varies depending on the absorption of wood
#220 Sandpaper can be used for the first coat and #400 Sandpaper can be used for the second and third coats
Apply 2 coats of either Melamine Glossy Clear or Matt Clear depending on the requirement, with an interval of 8 hrs between subsequent coats. Sanding of the 1st coat of top coat shall be done with #600 or #1000 Sandpaper
MRF Woodstains Interior shades can be used to enhance the colour of the wood grain. The available shades can be used over either the first coat or the second coat of sealer clear sanding of the applied shade is not permitted
For Interior applications use Woodstains Interior shades only
- Manual Brush Application
- Conventional Spray, Nozzle orifice: 0.059 inches, Pressure: 35 – 45 psi
- Thinner Recommended – Thinner 3830
Melamine Sealer Clear | 25 – 30% |
Melamine Matt Clear | 25 – 30% |
Melamine Glossy Clear | 25 – 30% |